Ad
related to: ford obd location
Search results
Results from the WOW.Com Content Network
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
OBD-II is an improvement over OBD-I in both capability and standardization. The OBD-II standard specifies the type of diagnostic connector and its pinout, the electrical signalling protocols available, and the messaging format. It also provides a candidate list of vehicle parameters to monitor along with how to encode the data for each.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The Ford EEC or Electronic Engine Control is a series of ECU (or Engine Control Unit) that was designed and built by Ford Motor Company. The first system, EEC I, used processors and components developed by Toshiba in 1973. It began production in 1974, and went into mass production in 1975. It subsequently went through several model iterations.
First Ford factory in the USA built outside the Detroit area. Location of first UAW strike against Ford and where the 20 millionth Ford vehicle was assembled. Last vehicle produced was a 1957 Ford Fairlane Custom 300 on December 28, 1956. 2,337,863 vehicles were produced at the Winchester Ave. plant. Replaced by Claycomo plant in 1957. KY
Assembly Line Diagnostic Link, Assembly Line Data Link, or ALDL is a proprietary on-board diagnostics system developed by General Motors before the standardization of OBD-2. It was previously called Assembly Line Communications Link or ALCL.
OBD 1 vs OBD 2 the vehicle will also dictate what the scan tool is able to display. If the vehicle is equipped with OBD 1 it will have significantly less available data when compared to a vehicle equipped with OBD 2. [3] When a vehicle detects a problem, it generates a DTC code which is a unique code that corresponds to the specific problem ...
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
Ad
related to: ford obd location