Search results
Results from the WOW.Com Content Network
The spoilers, situated inboard and forward of the trailing edge, are used for lateral control at high speeds to prevent excessive wing twist. [ 4 ] The Mitsubishi Diamond Jet, Beechjet, and Hawker 400 family of business aircraft incorporate full length spoilerons that also double as speed spoilers during flight and landing.
A flaperon (a portmanteau of flap and aileron) on an aircraft's wing is a type of control surface that combines the functions of both flaps and ailerons. Some smaller kitplanes have flaperons for reasons of simplicity of manufacture, while some large commercial aircraft such as the Boeing 747 , 767 , 777 , and 787 may have a flaperon between ...
Some aircraft are equipped with "flaperons", which are more commonly called "inboard ailerons" [citation needed]. These devices function primarily as ailerons, but on some aircraft, will "droop" when the flaps are deployed, thus acting as both a flap and a roll-control inboard aileron.
The solution applied for both of these issues was via management of the elevons; specifically, as the aircraft speed varied, the active ratio between the inboard and outboard elevons was adjusted considerably. Only the innermost elevons, which are attached to the stiffest area of the wings, would be active while Concorde was flown at high ...
A 260-horsepower (190 kW) diesel inboard motor An inboard motor is a marine propulsion system for boats.As opposed to an outboard motor, where an engine is mounted outside the hull of the craft, an inboard motor is an engine enclosed within the hull of the boat, usually connected to a propulsion screw by a driveshaft.
A pump-jet, hydrojet, water jet, or jet drive uses a ducted propeller (axial-flow pump), centrifugal pump, or mixed flow pump to create a jet of water for propulsion. These incorporate an intake for source water and a nozzle to direct its flow out, generating momentum, and in most cases, employing thrust vectoring to steer the craft.
A single surface on each wing serves both purposes: Used as an aileron, the flaperons left and right are actuated differentially; when used as a flap, both flaperons are actuated downwards. When a flaperon is actuated downward (i.e., used as a flap), there is enough freedom of movement left to be able to still use the aileron function.
The trailing edge is where the upper and lower surfaces of a wing meet. The angle between the upper and lower surfaces at the trailing edge is called the trailing edge angle. If the trailing edge angle is zero it is described as a cusped trailing edge. [5]