enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. AS/NZS 3112 - Wikipedia

   en.wikipedia.org/wiki/AS/NZS_3112

   "A single switch may be used for the control of two socket-outlets located immediately adjacent to each other". (subject to the current rating of the switch to be at least equal to the (a) total current rating of the sockets concerned; or (b) the current rating of the overcurrent protection device concerned, whichever is the lesser value.) [9]

3. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   Toggle the table of contents. ... are: 20, 30, 60, 100, 200, 300, 350, 500 and 600, ... so double pole breaking RCDs and main switches are recommended. When sockets ...

4. Multiway switching - Wikipedia

   en.wikipedia.org/wiki/Multiway_switching

   These switches appear externally similar to single pole, single throw (SPST) switches, but have extra connections which allow a circuit to be controlled from multiple locations. Toggling the switch disconnects one "traveler" terminal and connects the other. Electrically, a typical "3-way" switch is a single pole, double throw (SPDT) switch. By ...

5. H-bridge - Wikipedia

   en.wikipedia.org/wiki/H-bridge

   A "double pole double throw" (DPDT) relay can generally achieve the same electrical functionality as an H-bridge (considering the usual function of the device). However a semiconductor-based H-bridge would be preferable to the relay where a smaller physical size, high speed switching, or low driving voltage (or low driving power) is needed, or ...

6. Double switching - Wikipedia

   en.wikipedia.org/wiki/Double_switching

   A double-switched relay cannot close inadvertently with the application of the same current. At least two separate faults would be required to allow this relay to close inadvertently. Double switching , double cutting , or double breaking is the practice of using a multipole switch to close or open both the positive and negative sides of a DC ...

7. Light switch - Wikipedia

   en.wikipedia.org/wiki/Light_switch

   A toggle light switch Internal components of a toggle switch. The toggle mechanism provides "snap-action" through the use of an "over-center" geometry. The design was patented in 1916 by William J. Newton and Morris Goldberg. [2] The switch actuator does not control the contacts directly, but through an intermediate arrangement of springs and ...