enow.com Web Search

  1. Ads

    related to: engine coolant system pressure tester adapters

Search results

  1. Results from the WOW.Com Content Network
  2. OBD-II PIDs - Wikipedia

    en.wikipedia.org/wiki/OBD-II_PIDs

    OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.

  3. Radiator (engine cooling) - Wikipedia

    en.wikipedia.org/wiki/Radiator_(engine_cooling)

    A calibrated pressure-relief valve is usually incorporated in the radiator's fill cap. This pressure varies between models, but typically ranges from 4 to 30 psi (30 to 200 kPa). [4] As the coolant system pressure increases with a rise in temperature, it will reach the point where the pressure relief valve allows excess pressure to escape.

  4. Core plug - Wikipedia

    en.wikipedia.org/wiki/Core_plug

    Core plugs can also sometimes prevent freeze damage to the motor. During the early stages of the freezing of the engine coolant a freeze plug will sometimes burst, and thus allow the coolant to exit the engine, before it might expand within the engine during the freezing process and potentially crack the engine block. [2]

  5. Internal combustion engine cooling - Wikipedia

    en.wikipedia.org/wiki/Internal_combustion_engine...

    The temperature of the cooling air may range from well below freezing to 50 °C. Further, while engines in long-haul boat or rail service may operate at a steady load, road vehicles often see widely varying and quickly varying load. Thus, the cooling system is designed to vary cooling so the engine is neither too hot nor too cold.

  6. Coolant - Wikipedia

    en.wikipedia.org/wiki/Coolant

    A coolant is a substance, typically liquid, that is used to reduce or regulate the temperature of a system. An ideal coolant has high thermal capacity, low viscosity, is low-cost, non-toxic, chemically inert and neither causes nor promotes corrosion of the cooling system. Some applications also require the coolant to be an electrical insulator.

  7. Heater core - Wikipedia

    en.wikipedia.org/wiki/Heater_core

    The internal combustion engine in most cars and trucks is cooled by a water and antifreeze mixture that is circulated through the engine and radiator by a water pump to enable the radiator to give off engine heat to the atmosphere. Some of that coolant can be diverted through the heater core to give some engine heat to the cabin, or adjust the ...

  1. Ads

    related to: engine coolant system pressure tester adapters