Search results
Results from the WOW.Com Content Network
Then, the command ipconfig /renew is executed to request a new IP address. [3] [4] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is taken ...
Modems always start out in command mode when powered up. Here are the ways a modem can switch to data mode: After a successful dial-out connection in response to an "ATD" dial command in which the modem reaches another modem. After answering the phone with the "ATA" answer command, if another modem is on the other end.
User at modem A issues a dial command: AT-Get the modem's ATtention; D-Dial; T-Touch-Tone; 12125550100-Call this number RING: Modem A begins dialing. Modem B's phone-line rings, and the modem reports the fact. ATA: Computer at modem B issues answer command. CONNECT: CONNECT: The modems connect, and both modems report "connect".
Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure everything was reset. Just wait about five minutes before turning it back on to make sure everything was reset.
The command removes and corrects preloaded entries using a number of case-sensitive switches. The nbtstat -a < name > command performs a NetBIOS adapter status command on the computer name specified by < name >. The adapter status command returns the local NetBIOS name table for that computer as well as the MAC address of the adapter card. The ...
Additionally, command line switches, or other parameter strings, can be supplied on the command line. Spaces and symbols such as a "/" or a "-" may be used to allow the command processor to parse the command line into filenames, file specifications, and other options.
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
On some systems, the protocol name may be followed by "4" or "6", depending on whether the protocol is running over IPv4 or IPv6. Local Address – The IP address of the local computer and the port number being used. The name of the local computer that corresponds to the IP address and the name of the port is shown unless the -n parameter is ...