Search results
Results from the WOW.Com Content Network
A fuel–air explosive (FAE) device consists of a container of fuel and two separate explosive charges. After the munition is dropped or fired, the first explosive charge bursts open the container at a predetermined height and disperses the fuel in a cloud that mixes with atmospheric oxygen (the size of the cloud varies with the size of the ...
While not a gas, it is possible to synthesize an ultralight aerogel with a density less than air, the lightest recorded so far reaching a density approximately 1/6th that of air. [12] Aerogels don't float in ambient conditions, however, because air fills the pores of an aerogel's microstructure, so the apparent density of the aerogel is the sum ...
A balloon filled with gaseous hydrogen exploding.. A gas explosion is the ignition of a mixture of air and flammable gas, typically from a gas leak. [1] In household accidents, the principal explosive gases are those used for heating or cooking purposes such as natural gas, methane, propane, butane.
The term is considered by many safety professionals to be the same as the lower explosive level (LEL). At a concentration in air lower than the LFL, gas mixtures are "too lean" to burn. Methane gas has an LFL of 4.4%. [1] If the atmosphere has less than 4.4% methane, an explosion cannot occur even if a source of ignition is present.
The yield of the explosion was determined by using the equation: = () where is a dimensionless constant that is a function of the ratio of the specific heat of air at constant pressure to the specific heat of air at constant volume. The value of C is also affected by radiative losses, but for air, values of C of 1.00-1.10 generally give ...
Any fuel-air mixture higher than this would be too concentrated to result in combustion. The values existing between these two limits represent the flammable or explosive range. Within this threshold, give an external ignition source, combustion of the particular fuel would likely happen.
When the gunpowder was lit in the air-filled side, the rise in pressure would drive the water up the other side. [11] Like early steam engine designs, these engines used the air or vacuum created by gunpowder to directly lift the water. There were no mechanical parts in the manner of modern engines, which translate the power in the gas pressure ...
A contact explosive is a chemical substance that explodes violently when it is exposed to a relatively small amount of energy (e.g. friction, pressure, sound, light). Though different contact explosives have varying amounts of energy sensitivity , they are all much more sensitive relative to other kinds of explosives.