enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Chevrolet small-block engine (first- and second-generation)

   en.wikipedia.org/wiki/Chevrolet_small-block...

   The large-journal connecting rods were thicker (heavier) and used 3 ⁄ 8 in (9.5 mm) diameter cap-bolts to replace the small-journal's 11/32. 1968 blocks were made in 2-bolt and 4-bolt versions with the 4-bolt center-three main caps each fastened by two additional bolts which were supported by the addition of thicker crankcase main-web bulkheads.

3. Main bearing - Wikipedia

   en.wikipedia.org/wiki/Main_bearing

   The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).

4. List of GM bellhousing patterns - Wikipedia

   en.wikipedia.org/wiki/List_of_GM_bellhousing...

   Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.

5. General Motors LS-based small-block engine - Wikipedia

   en.wikipedia.org/wiki/General_Motors_LS-based...

   The small-block's 4.4 in (110 mm) bore spacing is retained, requiring pressed-in cylinder liners. The crankshaft and main bearing caps are forged steel for durability, the connecting rods are forged titanium, and the pistons are hypereutectic. The two-valve arrangement is retained, though the titanium intake valves by Del West have grown to 2.2 ...

6. Chevrolet Stovebolt engine - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_Stovebolt_engine

   The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.

7. Chrysler LA engine - Wikipedia

   en.wikipedia.org/wiki/Chrysler_LA_engine

   The cylinder block remained basically the same. It was still a V-shaped, 90-degree design made of cast iron. The crankshaft, located to the bottom of the block by five main bearing caps, was cast steel, and the eight connecting rods were forged steel. The pistons were cast aluminum, with a hypereutectic design. [8]