Search results
Results from the WOW.Com Content Network
An interior gateway protocol (IGP) or interior routing protocol is a type of routing protocol used for exchanging routing table information between gateways (commonly routers) within an autonomous system (for example, a system of corporate local area networks). [1] This routing information can then be used to route network-layer protocols like IP.
Open Shortest Path First (OSPF) is a routing protocol for Internet Protocol (IP) networks. It uses a link state routing (LSR) algorithm and falls into the group of interior gateway protocols (IGPs), operating within a single autonomous system (AS). OSPF gathers link state information from available routers and constructs a topology map of the ...
Examples of link-state routing protocols include Open Shortest Path First (OSPF) and Intermediate System to Intermediate System (IS-IS). [2] The link-state protocol is performed by every switching node in the network (i.e., nodes which are prepared to forward packets; in the Internet, these are called routers). [3]
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
1 A pivotal difference between Android and the other Linux kernel-based operating systems is the C standard library: Android's libbionic is different in that it does not aim to support POSIX to the same extent as the other libraries.
SMPP Short Message Peer-to-Peer; SOCKS "SOCKetS" ZIP Zone Information Protocol {For AppleTalk} This layer provides session management capabilities between hosts. For example, if some host needs a password verification for access and if credentials are provided then for that session password verification does not happen again.
The opaque LSAs, types 9, 10, and 11, are designated for upgrades to OSPF for application-specific purposes. For example, OSPF-TE has traffic engineering extensions to be used by RSVP-TE in Multiprotocol Label Switching (MPLS). Opaque LSAs are used to flood link color and bandwidth information.
That value was chosen because the maximum length of the data field of an Ethernet 802.3 frame is 1500 bytes and 1536 is equivalent to the number 600 in the hexadecimal numeral system. Thus, values of 1500 and below for this field indicate that the field is used as the size of the payload of the Ethernet frame while values of 1536 and above ...