Search results
Results from the WOW.Com Content Network
A = bend angle in degrees (the angle through which the material is bent) The neutral line (also called the Neutral axis ) is an imaginary profile that can be drawn through a cross-section of the workpiece that represents the locus where no tensile or compressive stress are present but shear stresses are at their maximum.
Bend radius, which is measured to the inside curvature, is the minimum radius one can bend a pipe, tube, sheet, cable or hose without kinking it, damaging it, or shortening its life. The smaller the bend radius, the greater the material flexibility (as the radius of curvature decreases , the curvature increases ).
An aluminium alloy (UK/IUPAC) or aluminum alloy (NA; see spelling differences) is an alloy in which aluminium (Al) is the predominant metal. The typical alloying elements are copper , magnesium , manganese , silicon , tin , nickel and zinc .
This page was last edited on 16 November 2024, at 12:16 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Due to its high strength and fatigue resistance, 2024 is widely used in aircraft, especially wing and fuselage structures under tension. [6] [7] Additionally, since the material is susceptible to thermal shock, 2024 is used in the qualification of liquid penetrant tests outside of normal temperature ranges.
An induction coil is placed around a small section of the pipe at the bend point. It is then induction heated to between 800 and 2,200 degrees Fahrenheit (430 and 1,200 C). While the pipe is hot, pressure is placed on the pipe to bend it. The pipe can then be quenched with either air or water spray or be cooled against ambient air.
Aluminum: 91.5 - 95.5 Copper: 3.5 - 4.5 Iron: 0.7 max Manganese: 0.4 - 1 Magnesium: 0.4 - 0.8 Silicon: 0.2 - 0.8 Zinc: 0.25 max Titanium: 0.15 max Chromium: 0.1 max ...
6105 aluminium alloy is an alloy in the wrought aluminium-magnesium-silicon family (6000 or 6xxx series). It is one of the least common of the alloys in this series. While most wrought aluminium alloys are covered by multiple standards (from any mixture of ASTM, EN, ISO, and national standard bodies), 6105 is only dealt with in ASTM B221: Standard Specification for Aluminum and Aluminum-Alloy ...