Search results
Results from the WOW.Com Content Network
A splice joint is a method of joining two members end to end in woodworking. [1] The splice joint is used when the material being joined is not available in the length required. It is an alternative to other joints such as the butt joint and the scarf joint. Splice joints are stronger than unreinenforced butt joints and have the potential to be ...
Crosswall construction is a building technique that uses prefabricated concrete modules with load-bearing walls that act to communicate the entire weight of the building to its foundation. [ 1 ] [ 2 ] [ 3 ]
The 1915 textbook Practical Electric Wiring describes the construction of the Western Union splice; short tie and long tie. The short tie splice has it being formed after stripping the insulation from a pair of wires for several inches, each, crossing the wires left over right as shown in figure part A; then, a hooked cross (figure part B) is formed holding the crossing point of the two wires ...
A wall mock-up. This detail compares the original design (left) and the submitted alternate detail for the skywalks at the Hyatt Regency, Kansas City. The proposed alternate compounded the loads on the bolts, which resulted in the skywalks collapsing on July 17, 1981. 114 people were killed. This example illustrates the importance of submittal ...
Kit-of-parts construction is a special subset of pre-fabrication that not only attempts to achieve flexibility in assembly and efficiency in manufacture, but also by definition requires a capacity for demountability, disassembly, and reuse. Kit-of-parts structures can be assembled and taken apart in a variety of ways like a construction toy.
In structural engineering and construction, a gusset plate is a plate for connecting beams and girders to columns. A gusset plate can be fastened to a permanent member either by bolts, rivets or welding or a combination of the three. [1] They are used in bridges and buildings, as well as other structures. [1]
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
A mechanical splice is a junction of two or more optical fibers that are aligned and held in place by a self-contained assembly (usually the size of a large carpenter's nail). [1] The fibers are not permanently joined, just precisely held together so that light can pass from one to another.