Search results
Results from the WOW.Com Content Network
Again, the term refers to the lock mechanism, so a lock can be both a mortise lock and a lever tumbler lock. In the modern lever tumbler lock, the key moves a series of levers that allow the bolt to move in the door. [5] Pin tumbler lock, commonly used for mortise locks in the US. The next major innovation to mortise lock mechanisms came in 1865.
The pick is then used to lift each lever inside the lock to the correct height so that the locking bolt can pass. Higher security lever locks (such as the five-lever) usually have notches cut into the levers. These catch the locking bolt and prevent it from moving if picking is attempted (similar to the security pins in a pin tumbler lock).
A mortise is a hole cut into a timber to receive a tenon. There are several kinds of mortise: [16] Open mortise: a mortise that has only three sides. (See bridle joint). Stub mortise: a shallow mortise, the depth of which depends on the size of the timber; also a mortise that does not go through the workpiece (as opposed to a "through mortise").
Turning a valve knob or lever adjusts flow by varying the aperture of the control device in the valve assembly. The result when opened in any degree is a choked flow . Its rate is independent of the viscosity or temperature of the fluid or gas in the pipe, and depends only weakly on the supply pressure , so that flow rate is stable at a given ...
Keys for some types of warded locks often have a characteristic symmetrical shape. The one on the right is a skeleton key. A warded lock (also called a ward lock) is a type of lock that uses a set of obstructions, or wards, to prevent the lock from opening unless the correct key is inserted.
The mortise is increased in size to receive a pair of folding wedges each side of the tenon. The hammer-headed key is used where there is no straight member to form the tenon. It is difficult to form a strong tenon on curved cut timber as the short grain there will weaken it, so two mortise sockets are formed one in each piece and a separate ...
Most of the lever itself is hidden, but both pallets are visible. The lever escapement, invented by the English clockmaker Thomas Mudge in 1754 (albeit first used in 1769), is a type of escapement that is used in almost all mechanical watches, as well as small mechanical non-pendulum clocks, alarm clocks, and kitchen timers.
The rocker ratio is the distance travelled by the valve divided by the distance travelled by the pushrod effective. The ratio is determined by the ratio of the distances from the rocker arm's pivot point to the point where it touches the valve and the point where it touches the pushrod/camshaft.