Search results
Results from the WOW.Com Content Network
0.1 mPa is the lowest direct measurement of pressure that is possible with current technology. Other vacuum gauges can measure lower pressures, but only indirectly by measurement of other pressure-dependent properties. These indirect measurements must be calibrated to SI units by a direct measurement, most commonly a McLeod gauge. [22]
Mean effective pressure. The mean effective pressure (MEP) is a quantity relating to the operation of a reciprocating engine and is a measure of an engine's capacity to do work that is independent of engine displacement. [1] Despite having the dimension of pressure, MEP cannot be measured. [2]
0.8–2 MPa 120–290 psi Pressure used in boilers of steam locomotives [citation needed] 1.1 MPa 162 psi Pressure of an average human bite [citation needed] 2.8–8.3 MPa 400–1,200 psi Pressure of carbon dioxide propellant in a paintball gun [64] 5 MPa 700 psi Water pressure of the output of a coin-operated car wash spray nozzle [58] 5 MPa ...
Hydraulic head. Fluid flows from the tank at the top to the basin at the bottom under the pressure of the hydraulic head. Hydraulic head or piezometric head is a specific measurement of liquid pressure above a vertical datum. [1][2] It is usually measured as a liquid surface elevation, expressed in units of length, at the entrance (or bottom ...
Pascal's law (also Pascal's principle[1][2][3] or the principle of transmission of fluid-pressure) is a principle in fluid mechanics given by Blaise Pascal that states that a pressure change at any point in a confined incompressible fluid is transmitted throughout the fluid such that the same change occurs everywhere. [4]
Dynamic pressure. In fluid dynamics, dynamic pressure (denoted by q or Q and sometimes called velocity pressure) is the quantity defined by: [1] where (in SI units): u is the flow speed in m/s. It can be thought of as the fluid's kinetic energy per unit volume. For incompressible flow, the dynamic pressure of a fluid is the difference between ...
˙ is the apparent shear rate (s −1), σ is the shear stress (Pa), η a is the apparent viscosity (Pa·s), ∆P is the pressure difference between the leading pressure sensor and the last pressure sensor (Pa), Q is the flow rate (ml/s), w is the width of the flow channel (mm), h is the depth of the flow channel (mm),
Pressure head. In fluid mechanics, pressure head is the height of a liquid column that corresponds to a particular pressure exerted by the liquid column on the base of its container. It may also be called static pressure head or simply static head (but not static head pressure). Mathematically this is expressed as: