Search results
Results from the WOW.Com Content Network
PC/104 is an embedded computer standard which defines both a form factor and computer bus. PC/104 is intended for embedded computing environments. Single-board computers built to this form factor are often sold by COTS vendors, which benefits users who want a customized rugged system, without months of design and paper work.
A Serial ATA port multiplier (SATA PM) is a device that allows multiple SATA devices to be connected to a single SATA host port. Many common controllers do not support this feature, [ 1 ] as it is not a requirement for a SATA controller.
The Advanced Host Controller Interface (AHCI) is a technical standard defined by Intel that specifies the register-level interface of Serial ATA (SATA) host controllers in a non-implementation-specific manner in its motherboard chipsets.
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
On a desktop computer the port is simply a connector, usually mounted on a bracket at the back accessible from outside the machine, connected to motherboard sources of SATA, USB, and power at 5 V and 12 V. No change is required to drivers, registry or BIOS settings and the USB support is independent of the SATA connection. [citation needed]
The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]
Socket L was intended for enthusiasts who wanted server power in a desktop PC. It is just a re-branded Socket F that doesn't need special RAM, and may have only been used in the Asus L1N64-SLI WS Motherboard. Socket AM2+ 2007 AMD Athlon 64 AMD Athlon X2 AMD Phenom AMD Phenom II: Desktop PGA: 940 1.27 [9] 200–2600 MHz Separated power planes