Search results
Results from the WOW.Com Content Network
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
Two video matrix units in a rack. A video router, also known as a video matrix switch or SDI router, is an electronic switch designed to route video signals from multiple input sources such as cameras, VT/DDR, computers and DVD players, to one or more display devices, such as monitors, projectors, and TVs.
Serial digital interface (SDI) and HD-SDI. CoaXPress; 75 Ω for video signal (SDI and CoaXPress) on, for example, RG59 and RG6. 50 Ω for data link, like Ethernet on RG58. 93 Ω on RG62. 50 Ω (white/bottom row) and 75 Ω C connectors (red/top row) C connector (Concelman connector) General Radio 874 connectors GR connector (General Radio connector)
SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...
Network Device Interface (NDI) is a software specification developed by the technology company NewTek.It enables high-definition video to be transmitted, received, and communicated over a computer network with low latency and high quality.
If an SDTI stream is viewed using a standard SDI device, then the raw data can be seen as a small strip along the left-hand side (usually in purple). The DVCAM SDTI has video data at the top, control data in the middle (Timecode, etc.) and audio at the bottom just like it is organised on the tape.
The IRD is the interface between a receiving satellite dish or Telco networks and a broadcasting facility video/audio infrastructure. Professional IRDs have various features that consumer IRDs lack such as: SDI outputs. ASI inputs / outputs. TSoIP inputs. AES/EBU Audio decoding. VBI reinsertion. WSS data and pass through. Transport stream ...
Level A format is the direct mapping of uncompressed 1080p (up to 60 fps) video into a serial digital interface at the nominal 3 Gbit/s. That is, one video signal, one video stream, in one cable. Level B-DL format is the mapping of dual-link HD-SDI/SMPTE 372M (i.e.: 1080p up to 60 fps) in a single serial digital interface at the nominal 3 Gbit ...