Search results
Results from the WOW.Com Content Network
Presta valves use air pressure to hold the valve closed, then use a small nut to ensure the valve stays sealed in use. Loosening the nut takes time, which is a disadvantage for racing. Leaving the nut loose still allows the valve to seal, but may make it easier to have accidental (or malicious) deflation.
Presta valves (also called Sclaverand valves or French valves) are normally only used on bicycles. The stem has a narrower diameter (nominally 6 mm) than the thinnest (nominally 8 mm) Schrader type, and so the bore of the hole in the rim through which the stem passes can be smaller. Has a locknut that needs to be opened to inflate/deflate. [17 ...
The Dunlop valve has a wider base than a Presta valve, similar enough in size to a Schrader valve to use identically drilled valve holes in rims, [3] but it can be inflated with a Presta valve adapter. [4] The inner mechanism of the valve can be replaced easily, without the need for special tools.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over bumps, into potholes, or otherwise reacting to the irregularities of a ...
The Schrader valve is used on virtually all automobile tires and motorcycle tires and most wider-rimmed bicycle tires.In addition to tube and tubeless tires, Schrader valves of varying diameters are used on many refrigeration and air conditioning systems to allow servicing, including recharging with refrigerant; by plumbers conducting leak-down pressure tests on pipe installations; as a ...
The common valve spring system is satisfactory for traditional mass-produced engines that do not rev highly and are of a design that requires low maintenance. [1] At the period of initial desmodromic development, valve springs were a major limitation on engine performance because they would break from metal fatigue.
The new valve train mechanism reduced the valves angle from 33⁰ to 21⁰. [10] This revised engine can be identified by the use of a different plastic engine cover. Another update was occurred in 2012, the compression ratio was increased to 11.0:1. [26] The older version was still in use for selected Japanese market Toyota cars up until 2014.