Search results
Results from the WOW.Com Content Network
At lower speeds, the DSR system will increase the steering ratio by having the electric motor provide more assistance to the hydraulic steering system. [2] Thus, less torque is needed to be applied to the steering wheel when making sharp turns. This makes the action of steering feel lighter and more controlled. [5]
SpeedE, an academic concept car developed for studying drive-by-wire technologies [1] [2]. Steer-by-wire, in the context of the automotive industry, is a technology or system that allows steering some or all of a vehicle's wheels without a steering column that turns the direction of those wheels mechanically.
When ESC detects loss of steering control, it automatically applies the brakes to help steer the vehicle where the driver intends to go. Braking is automatically applied to wheels individually, such as the outer front wheel to counter oversteer, or the inner rear wheel to counter understeer. Some ESC systems also reduce engine power until ...
A steering box design, such as recirculating ball, is much less sensitive. Despite this, the other advantages of rack and pinion steering have led to its almost universal adoption, at least for light automobiles. Steering kickback is distinct from torque steering, bump steer or roll steer. These are similar outside influences that affect the ...
A vehicle with a steer-by-wire system may be manually controlled by a driver through a steering wheel, a yoke, or any other steering apparatus which is connected to one or more electronic control units, which uses the input to control steering actuators that turn the wheels and steer the vehicle. The steering wheel or yoke may be equipped with ...
Torque steer is the unintended influence of engine torque on the steering, especially in front-wheel-drive vehicles. For example, during heavy acceleration, the steering may pull to one side, which may be disturbing to the driver.
This was achieved by making the linkage not a simple parallelogram, but by making the length of the track rod (the moving link between the hubs) shorter than that of the axle, so that the steering arms of the hubs appeared to "toe out". As the steering moved, the wheels turned according to Ackermann, with the inner wheel turning further. [3]
The back end will swing out and the vehicle will turn toward the inside of the curve. If the steering angle is not changed, then the front wheels will trace out a smaller and smaller circle while the rear wheels continue to swing around the front of the car. This is what is happening when a car 'spins out'.