Search results
Results from the WOW.Com Content Network
Watt's indicator diagram. The PV diagram, then called an indicator diagram, was developed in 1796 by James Watt and his employee John Southern. [2] Volume was traced by a plate moving with the piston, while pressure was traced by a pressure gauge whose indicator moved at right angles to the piston. A pencil was used to draw the diagram.
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
An indicator diagram is a chart used to measure the thermal, or cylinder, performance of reciprocating steam and internal combustion engines and compressors. [1] An indicator chart records the pressure in the cylinder versus the volume swept by the piston, throughout the two or four strokes of the piston which constitute the engine, or ...
Reciprocating pump has wide application and to clear the basic idea it is necessary to know the basic parts. The basic parts along with its function; Water reservoir - it is not a part of reciprocating pump, however, it is the main source where from the reciprocating pump takes the water. It may be a source of other fluid as well.
Pressure in blanketed tanks is maintained by self actuating pressure control valves (PCVs). As liquid is withdrawn from the tank the pressure in the gas space falls. The blanket gas supply valve opens to maintain the pressure. As the tank fills with liquid the pressure rises and a vent gas valve open to vent gas to atmosphere or a vent system. [11]
A desmodromic valve is a reciprocating engine poppet valve that is positively closed by a cam and leverage system, rather than by a more conventional spring. The valves in a typical four-stroke engine allow the air/fuel mixture into the cylinder at the beginning of the cycle and exhaust spent gases at the end of the cycle.
The map may be produced by driving the compressor with an electric motor with the flow resistance selected artificially using a variable area throttle valve. The compressor may also be mapped if it is part of a gas generator with a valve at the turbine exit. Campbell [10] shows a General Electric J79 compressor mapped in this way.
The upper part of the valve stem, within the rocker box, is lubricated by oil. If this oil travels unchecked along the valve stem, engine HC emissions will become excessive. To control this, an elastomeric seal is fitted over the top of the valve guide. These may wear or stiffen with age, so are usually replaced whenever valves are removed for ...