enow.com Web Search

  1. Ads

    related to: depth of discharge socket for faucet in kitchen counter height in mm

Search results

  1. Results from the WOW.Com Content Network
  2. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

  3. Drainage equation - Wikipedia

    en.wikipedia.org/wiki/Drainage_equation

    the permissible long term average depth of the water table (Dw) on the basis of agricultural drainage criteria; the soil's hydraulic conductivity (Ka and Kb) by measurements; the depth of the bottom of the aquifer (Di) the design drain spacing (L) can be found from the equation in dependence of the drain depth (Dd) and drain radius (r ...

  4. Low-flow fixtures - Wikipedia

    en.wikipedia.org/wiki/Low-flow_fixtures

    Faucets that meet energy efficiency standards for WaterSense mustn’t use more than 1.5 gpm, a 32% decrease in flow rate over the federal requirement. [10] Reduced flow faucets often make use of flow restrictors or faucet aerators to reduce the flowrate of the water. Using a faucet with an aerator results in an average 42% reduction in water ...

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    These compression connections on water shutoff valves under a kitchen sink show evidence of slow seepage (greenish deposits). Valves stop (or regulate) the flow of liquids or gases. They are categorized by application, such as isolation, throttling, and non-return.

  6. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    A fibre washer (which expands when wet, aiding the seal) is used between the connector and the tap tail. Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size.

  7. CEE 7 standard AC plugs and sockets - Wikipedia

    en.wikipedia.org/wiki/CEE_7_standard_AC_plugs...

    The CEE 7/5 socket and CEE 7/6 plug are defined in French standard NF C 61-314 "Plugs and socket-outlets for household and similar purposes" (which also includes CEE 7/7, 7/16 and 7/17 plugs) The socket has a predominantly circular recess which is 15 mm (0.591 in) deep with two symmetrical round apertures and a round 4.8 mm (0.189 in) earth pin ...

  1. Ads

    related to: depth of discharge socket for faucet in kitchen counter height in mm