Search results
Results from the WOW.Com Content Network
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks.The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
The IP MTU and Ethernet maximum frame size are configured separately. In Ethernet switch configuration, MTU may refer to Ethernet maximum frame size. In Ethernet-based routers, MTU normally refers to the IP MTU. If jumbo frames are allowed in a network, the IP MTU should also be adjusted upwards to take advantage of this.
In networking equipment, maximum jumbo frame size may be specified using either maximum frame size (maximum layer 2 packet size, includes frame headers) or maximum transmission unit (maximum layer 3 packet size, excludes frame headers), depending on the equipment's configuration interface. [citation needed]
If parity is specified and we use 2 stop bits, the overhead for carrying one 8 bit character is 4 bits (one start bit, one parity bit and two stop bits) - or 50%! In this case a 9600 bit/s connection will carry 9600/12 byte/s (800 byte/s). Asynchronous serial interfaces commonly will support bit transmission speeds of up to 230.4 kbit/s. If it ...
Enhanced Interior Gateway Routing Protocol (EIGRP) is an advanced distance-vector routing protocol that is used on a computer network for automating routing decisions and configuration. The protocol was designed by Cisco Systems as a proprietary protocol, available only on Cisco routers.
OSPF is a layer 3 protocol. If a layer 2 switch is between the two devices running OSPF, one side may negotiate a speed different from the other side. This can create an asymmetric routing on the link (Router 1 to Router 2 could cost '1' and the return path could cost '10'), which may lead to unintended consequences.
2 2 1 0 0 0 OTU3 40 43 Transports an OC-768 or STM-256 signal or a 40 Gigabit Ethernet signal. [5] 32 16 4 3 1 1 0 0 OTU3e1/2 [6] 41 44.5 develop for transport of 10G LAN PHY, and one for 10G WAN PHY, over SDH and OTN. 32 16 4 3 1 1 0 0 OTU50 50 52.8 Transports a 50 Gigabit Ethernet signal 40 20 5 5 2 1 1 0 OTU4 100 111.8
Distance-vector protocols update the routing tables of routers and determine the route on which a packet will be sent by the next hop which is the exit interface of the router and the IP address of the interface of the receiving router. Distance is a measure of the cost to reach a certain node.