Search results
Results from the WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
The result is expressed in inches and is usually (but not always) rounded to a convenient fraction. For instance, a 6.4x4.8 mm sensor has a diagonal of 8.0 mm and therefore an optical format of 8.0*3/2 = 12 mm, which is expressed as 1 ⁄ 2 inch in imperial units. The reason it is expressed in inches is historical, dating back to the early days ...
[2] [3] [4] The factor–label method is the sequential application of conversion factors expressed as fractions and arranged so that any dimensional unit appearing in both the numerator and denominator of any of the fractions can be cancelled out until only the desired set of dimensional units is obtained.
[1] The 7.62 mm designation refers to the internal diameter of the barrel at the lands (the raised helical ridges in rifled gun barrels). The actual bullet caliber is often 7.82 mm (0.308 in), although Soviet weapons commonly use a 7.91 mm (0.311 in) bullet, as do older British ( .303 British ) and Japanese ( 7.7×58mm Arisaka ) cartridges.
A 16-inch gun of 50 calibers (16" L/50) has a barrel length of 50 × 16 = 800 inches (66 ft 8 in). Both 14-in and 16-in navy guns were common in World War II. The British Royal Navy insisted on 50-cal guns on ships as it would allow 1,900 to 2,700 lb (860 to 1,220 kg) shells to travel at an initial velocity of up to 1,800 mph (2,897 km/h) to a ...
Different lengths as in respect to the electromagnetic spectrum, measured by the metre and its derived scales.The microwave is between 1 meter to 1 millimeter.. The millimetre (international spelling; SI unit symbol mm) or millimeter (American spelling) is a unit of length in the International System of Units (SI), equal to one thousandth of a metre, which is the SI base unit of length.
Gauge 2 (also called 2 gauge or II gauge) is a model railway gauge, originally 64 mm (2 + 1 ⁄ 2 in), [1] then standardised in 1909 at 2 in (50.8 mm), a 20% reduction and a change in definition: from mm to inch. [citation needed] It has since fallen into disuse. The gauge was introduced by Märklin at the Leipzig toy fair in 1891. Gauge 2 was ...
500 ml (1 ⁄ 2 L) 750 ml (3 ⁄ 4 L) 1 L; 1.5 L; 2 L; 3 L; 5 L; In the United States, the alcohol industry switched to metric bottle sizes on October 1, 1976, abandoning the existing 38 sizes of bottles and instead adopting the following 6 sizes: [2] 50 mL (miniature) 200 mL (replaced the half-pint) (≈237 mL is a U.S. half-pint)