enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. The 7 Best HDTV Antenna Amplifiers of 2023 For a Better Signal

   www.aol.com/lifestyle/best-high-definition-tv...

   8-Port TV Distribution Amplifier. For households with multiple TVs, the Antennas Direct 8-Port TV Distribution Amplifier can split a signal with no noticeable impact on signal quality.

3. Antenna amplifier - Wikipedia

   en.wikipedia.org/wiki/Antenna_amplifier

   In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

4. Television antenna - Wikipedia

   en.wikipedia.org/wiki/Television_antenna

   Outdoor antennas provide up to a 15 dB gain in signal strength and 15-20 dB greater rejection of ghost signals in analog TV. [6] Combined with a signal increase of 14 dB due to height and 11 dB due to lack of attenuating building walls, an outdoor antenna can result in a signal strength increase of up to 40 dB at the TV receiver. [6]

5. Low-noise block downconverter - Wikipedia

   en.wikipedia.org/wiki/Low-noise_block_downconverter

   The signal received by the LNB is extremely weak and it has to be amplified before downconversion. The low-noise amplifier section of the LNB amplifies this weak signal while adding the minimum possible amount of noise to the signal. The low-noise quality of an LNB is expressed as the noise figure (or sometimes noise temperature). This is the ...

6. Valve amplifier - Wikipedia

   en.wikipedia.org/wiki/Valve_amplifier

   6N3C power tube. A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal.Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.

7. Analog television - Wikipedia

   en.wikipedia.org/wiki/Analog_television

   The audio signal goes to a 4.5 MHz amplifier. This amplifier prepares the signal for the 4.5 MHz detector. It then goes through a 4.5 MHz IF transformer to the detector. In television, there are 2 ways of detecting FM signals. One way is by the ratio detector. This is simple but very hard to align. The next is a relatively simple detector.