Search results
Results from the WOW.Com Content Network
Where the plates meet, their relative motion determines the type of plate boundary (or fault): convergent, divergent, or transform. The relative movement of the plates typically ranges from zero to 10 cm annually. Faults tend to be geologically active, experiencing earthquakes, volcanic activity, mountain-building, and oceanic trench formation.
A transform fault or transform boundary, is a fault along a plate boundary where the motion is predominantly horizontal. [1] It ends abruptly where it connects to another plate boundary, either another transform, a spreading ridge, or a subduction zone. [2] A transform fault is a special case of a strike-slip fault that also forms a plate boundary.
The Motagua Fault, which crosses through Guatemala, is a transform boundary between the southern edge of the North American plate and the northern edge of the Caribbean plate. New Zealand's Alpine Fault is another active transform boundary. The Dead Sea Transform (DST) fault which runs through the Jordan River Valley in the Middle East.
Convergent and transform boundaries are responsible for most of the world's major (M w > 7) earthquakes. Convergent and divergent boundaries are also the site of most of the world's volcanoes, such as around the Pacific Ring of Fire. Most of the deformation in the lithosphere is related to the interaction between plates at or near plate boundaries.
When these are drawn onto the diagram containing the velocity triangle these lines must be able to meet at a single point, for the triple junction to exist stably. These lines necessarily are parallel to the plate boundaries as to remain on the plate boundaries the observer must either move along the plate boundary or remain stationary on it.
Earthquakes are common on the West Coast, with multiple plate boundaries like the San Andreas fault making geologic activity more likely. They are rarer on the East Coast, but they do happen .
There are three main types of faults: [1] normal faults, reverse faults and strike slip (transform) faults. All of these are ways the crust can deform is due to the different types of plate margins, which are: [ 2 ] divergent boundaries , convergent boundaries , and transform boundaries .
Stress is built up during the spreading movements at the plate boundary. The accumulated stress in transform fault zones is released during strike-slip earthquakes. The transform fault is induced by strike-slip motion that is transverse to the fault zone. The blocks between the faults are slightly rotated afterwards. A diagram (fig.2) is shown ...