Search results
Results from the WOW.Com Content Network
The following describes techniques to auto-widen, or expand, any wp:wikitable, based on each user's default text-size set for their browser or device.. The major technique is to pad columns with column-spacers, as groups of non-breaking spaces ( ) at the end of each column, such as by template {{ns|15}}, where those spaces will shift below the column on narrow screens, to move the columns ...
For winter sports, the term superpipe is used to describe a halfpipe built of snow which has walls 22 ft (6.7 m) high from the flat bottom on both sides. Other features of a superpipe are that the width of the pipe is greater than the height of the walls, and the walls extend to near vertical.
For the limiting case of a very wide duct, i.e. a slot of width b, where b ≫ a, and a is the water depth, then D H = 4a. For a fully filled duct or pipe whose cross-section is a convex regular polygon , the hydraulic diameter is equivalent to the diameter D {\displaystyle D} of a circle inscribed within the wetted perimeter .
In the absence of snow, dug out half-pipes can be used by dirt-boarders, motorcyclists, and mountain bikers. Performance in a half-pipe has been rapidly increasing over recent years. The current limit performed by a top-level athlete for a rotational trick in a half-pipe is 1440 degrees (four full 360 degree rotations).
Also, if the table has cell spacing (and thus border-collapse=separate), meaning that cells have separate borders with a gap in between, that gap will still be visible. A cruder way to align columns of numbers is to use a figure space   or  , which is intended to be the width of a numeral, though is font-dependent in practice:
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
During the IPS period, pipes were cast in halves and welded together, and pipe sizes referred to the inside diameters. [1] The inside diameters under IPS were roughly the same as the more modern Ductile Iron Pipe Standard (DIPS) and Nominal Pipe Size (NPS) Standards, and some of the wall thicknesses were also retained with a different ...
Pipe sizes can be confusing because the terminology may relate to historical dimensions. For example, a half-inch iron pipe does not have any dimension that is a half inch. Initially, a half inch pipe did have an inner diameter of 1 ⁄ 2 inch (13 mm)—but it also had thick walls. As technology improved, thinner walls became possible, but the ...