Search results
Results from the WOW.Com Content Network
Pin and hanger assembly. A pin and hanger assembly is used to connect two plate girders of a bridge.These assemblies are used to provide an expansion joint in the bridge. One beam (the anchor span) is set on a pier with a short section cantilevered out toward the next pier.
A expansion joint, or movement joint, is an assembly designed to hold parts together while safely absorbing temperature-induced expansion and contraction of building materials. They are commonly found between sections of buildings , bridges , sidewalks , railway tracks , piping systems , ships , and other structures.
The omission of the expansion joint removes a pathway for the penetration of chloride-bearing road salts to the bridge's sub-structure. In the United Kingdom there is a presumption that most new short to medium length bridges will be of the integral type. [citation needed] An early example of an integral bridge is masonry arch bridge.
A breather switch, expansion joint, or adjustment switch is an intentional gap in railway tracks to allow for thermal expansion in long sections of otherwise unbroken rail. . They are placed between very long sections of continuous welded rail or at the transition from continuous welded rail to jointed track, and commonly in the vicinity of bridges, viaducts and tunnels where the ...
Note that if the bridge has an expansion joint (a discontinuity), the sections of the bridge would be considered separate (by the definition of a continuous bridge) for the purposes of this ranking. The Yoshima Bridge is an example of this. It consists of two continuous-truss sections that together have five total spans.
An expansion bearing on the Queen Elizabeth II Metro Bridge. A bridge bearing is a component of a bridge which typically provides a resting surface between bridge piers and the bridge deck . The purpose of a bearing is to allow controlled movement and thereby reduce the stresses involved.
Examples of the latter are tripods, hiking poles, or similar telescoping device. The clamping mechanism is based on a cam, a set screw, or a similar locking mechanism. Slip joints can also be non-telescoping, such as the joints on some older wooden surveyor's levelling rods. These use a joint that keeps the sections offset from each other but ...
A prime example of this was his match-casting and segmental bridge section techniques. His match-casting invention consisted of pre-cast segmental sections being cast together and then separated. This made it possible for the sections to fit perfectly together when constructed at the job site, and reduced construction time significantly.