Search results
Results from the WOW.Com Content Network
Typical rivet nut Sectional view Sectional view, with bolt inserted. A rivet nut, also known as a blind rivet nut, or rivnut, [1] is a one-piece internally threaded and counterbored tubular rivet that can be anchored entirely from one side. It is a kind of threaded insert. There are two types: one is designed to form a bulge on the back side of ...
Cleco (Cleko) fasteners on an aircraft wing. A cleco, also spelled generically cleko, is a temporary fastener developed by the Cleveland Pneumatic Tool Company. [1] Widely used in the manufacture and repair of aluminum-skinned aircraft, it is used to temporarily fasten sheets of material together, or to hold parts such as stiffeners, frames etc together, before they are permanently joined.
The self-pierce rivet fully pierces the top sheet material(s) but only partially pierces the bottom sheet. As the tail end of the rivet does not break through the bottom sheet it provides a water or gas-tight joint. With the influence of the upsetting die, the tail end of the rivet flares and interlocks into the bottom sheet forming a low ...
This thread form also allows for the use of a split nut, which can compensate for nut wear. [8] The line of General Purpose (GP) Acme threads (ASME/ANSI B1.5-1997) are not designed to sustain external radial loads and both the nut and bolt are, ideally, independently supported (the nut by a linear guide and the screw by shaft bearings).
T-nuts. The left one has been inserted in the wood and a bolt has been screwed in from the other side. A T-nut, T nut, or tee nut (also known as a blind nut, [1] which can however also refer to a rivet nut or an insert nut, and likewise drive-in nut [2]) is a type of nut used to fasten a wood, particle or composite materials workpiece, leaving a flush surface.
Three well nuts. A well nut is a blind rivet-like type of fastener used to blindly fasten a piece (much like a molly bolt) and to seal the bolt hole.. They are often referred to by the proprietary name Rawlnut or Rawl nut, the name by which they are known in the UK.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
They are usually made of low grade steel, have a slot or Phillips drive, and are used to join sheet metal parts using a hex or square nut. [12] plow bolt: plough bolt: A plow bolt is bolt similar to a carriage bolt, except the head is flat or concave, and the underside of the head is a cone designed to fit in a countersunk recess.