Search results
Results from the WOW.Com Content Network
Once the engine spins to starting speed, centrifugal force causes the lever to move out of the way, and the exhaust valve is allowed to seat fully. [4] Older compression release systems used a small bump on the cam that would bump the valve very slightly at low speeds. Once the engine gained speed, the pressure would push the exhaust valve ...
The oil pump forces the motor oil through the passages in the engine to properly distribute oil to different engine components. In a common oiling system, oil is drawn out of the oil sump (oil pan, in US English) through a wire mesh strainer that removes some of the larger pieces of debris from the oil.
Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body. When the engine valve is closed (lifter in a neutral position), the lifter is free to fill with oil. As the camshaft lobe enters the lift phase of its travel, it compresses the lifter piston, and a valve shuts the oil inlet. Oil is ...
A supercharger is a "forced induction" system which uses a compressor powered by the shaft of the engine which forces air through the valves of the engine to achieve higher flow. When these systems are employed the maximum absolute pressure at the inlet valve is typically around 2 times atmospheric pressure or more.
Pneumatic valve springs are also found in several Moto GP motorcycle engines, debuting in 2002 with the Aprilia RS Cube. In 2005, Team Roberts was the first to use pneumatic valves full-time in their uncompetitive KTM powered bike. Today, almost all of the MotoGP teams use pneumatic valve technology on their bikes, including Yamaha, Suzuki and ...
A blowoff valve is designed to release pressure in the intake system when the throttle is closed. A "recirculating" type blowoff valve releases the pressurised air back into the non-pressurized section of the intake (i.e. upstream of the turbocharger), while an "atmospheric venting" type blowoff valve dumps the air directly into the atmosphere.
An automatic lubrication system consists of a reservoir with a pump, feed lines, metering valves, and injectors. The automatic lubrication system is connected to a control system via switchs. The control system may involve human input or may be computerised (computer numerical control or CNC). [2] [3]
The upper part of the valve stem, within the rocker box, is lubricated by oil. If this oil travels unchecked along the valve stem, engine HC emissions will become excessive. To control this, an elastomeric seal is fitted over the top of the valve guide. These may wear or stiffen with age, so are usually replaced whenever valves are removed for ...