Search results
Results from the WOW.Com Content Network
The cruise control takes its speed signal from a rotating driveshaft, speedometer cable, wheel speed sensor from the engine's RPM, or internal speed pulses produced electronically by the vehicle. Most systems do not allow the use of the cruise control below a certain speed - typically around 25 or 30 mph (40 or 48 km/h).
Early cars had a hand lever to control the throttle, either directly, or by controlling an engine speed governor which in turn controlled both the throttle and timing. [6] In 1900 the Wilson-Pilcher car was introduced in Britain which had a hand controlled speed governor, and a foot throttle which could override the action of the governor.
The emergency stop signal is automatically activated if the vehicle speed is greater than 50 km/h (31 mph) and the emergency braking logic defined by regulation No. 13 (heavy vehicles), 13H (light vehicles), or 78 (motorcycles) is activated; the ESS may be displayed when a light vehicle's deceleration is greater than 6 m/s 2 (20 ft/s 2) or a ...
The car will maintain the speed the driver sets until the driver hits the brake pedal, clutch pedal, or disengages the system. [37] Specific cruise control systems can accelerate or decelerate, but require the driver to click a button and notify the car of the goal speed. [37] ESC control light
An electronic speed control follows a speed reference signal (derived from a throttle lever, joystick, or other manual input) and varies the switching rate of a network of field effect transistors (FETs). [1] By adjusting the duty cycle or switching frequency of the transistors, the speed of the motor is changed. The rapid switching of the ...
Adaptive cruise control does not provide full autonomy: the system only provides some help to the driver, but does not drive the car by itself. [3] For example, the driver is able to set the cruise control to 55mph, if the car while traveling that speed catches up to another vehicle going only 45mph, the ACC will cause the car to automatically brake and maintain a safe distance behind the ...
The ECM is a type of electronic control unit (ECU), which is an embedded system that employs software to determine the required throttle position by calculations from data measured by other sensors, including the accelerator pedal position sensors, engine speed sensor, vehicle speed sensor, and cruise control switches.
Traffic signal preemption (also called traffic signal prioritisation) is a system that allows an operator to override the normal operation of traffic lights.The most common use of these systems manipulates traffic signals in the path of an emergency vehicle, halting conflicting traffic and allowing the emergency vehicle right-of-way, thereby reducing response times and enhancing traffic safety.