Search results
Results from the WOW.Com Content Network
Pages in category "1970s sailboat type designs" The following 200 pages are in this category, out of approximately 468 total. This list may not reflect recent changes .
On small sailboats, masts may be "stepped" (put in place) with the bottom end in a receptacle that is supported above the keel of the boat or on the deck or other superstructure that allows the mast to be raised at a hinge point until it is erect. Some masts are supported solely at the keel and laterally at the deck and are called "unstayed".
A hat block, also known as a hat form or bashing block, is a wooden block carved into the shape of a hat by a craftsman known as a block shaper. It is used by hat makers and milliners [1] to produce a hat. Today there are only a handful of block shapers left. In the United Kingdom, hat block making has been listed as an endangered craft by the ...
The Mirror 16 is a class of sailing dinghy which was sponsored by the Daily Mirror newspaper in 1963, and the design project was headed by Jack Holt.Its design was based upon the easy–to–construct stitch and glue principle introduced by Barry Bucknell for the Mirror 11 dinghy.
The Dark Harbor 17 1/2 is a 25 ft 10 in long class of sailboat designed by B.B.Crowninshield in 1908 as a daysailer and racer. [1] The mainsail is gaff rigged, with a jib that attaches to the masthead and bow. The displacement hull has a full keel hull with lead ballast and classic lines.
The Lido 14 is a recreational sailboat, built predominantly of fiberglass, with wood trim. It has a fractional sloop rig, with gold-colored anodized aluminum spars and a loose-footed mainsail . The hull features a spooned plumb stem , a near-vertical transom , a transom-hung rudder controlled by a tiller and a retractable centerboard that is ...
Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.
Lofting is particularly useful in boat building, when it is used to draw and cut pieces for hulls and keels. These are usually curved, often in three dimensions . Loftsmen at the mould lofts of shipyards were responsible for taking the dimensions and details from drawings and plans, and translating this information into templates, battens ...