Search results
Results from the WOW.Com Content Network
A small amount of fuel in the tank leaves pumps on the floor of the tank exposed to the air-fuel mixture, and an electric pump is a potential ignition source. The explosion of a Thai Airways International Boeing 737 in 2001 and a Philippine Airlines 737 in 1990 also occurred in tanks that had a small amount of residual fuel. These three ...
Because an inert purge gas is used, the purge procedure may (erroneously) be referred to as inerting in everyday language. This confusion may lead to dangerous situations. Carbon dioxide is a safe inert gas for purging. Carbon dioxide is an unsafe inert gas for inerting, as it may ignite the vapors and result in an explosion. [2]
Engine room sea water valves. A seacock is a valve on the hull of a boat or a ship, permitting water to flow into the vessel, such as for cooling an engine or for a salt water faucet; or out of the boat, such as for a sink drain or a toilet. Seacocks are often a Kingston valve. Seacocks are left open or are closed depending on the situation.
Purging is accomplished by pumping inert gas into the tank until hydrocarbons have been sufficiently expelled. Next the tank is gas freed which is usually accomplished by blowing fresh air into the space with portable air powered or water powered air blowers. "Gas freeing" brings the oxygen content of the tank up to 20.8% O 2. The inert gas ...
The flammability limits of the gas define those proportions, i.e. the ignitable range. In combustion engineering terms, the admission of inert gas can be said to dilute the oxygen below the limiting oxygen concentration. Inerting differs from purging. Purging, by definition, ensures that an ignitable mixture never forms. Inerting makes an ...
A pump-jet works by having an intake (usually at the bottom of the hull) that allows water to pass underneath the vessel into the engines. Water enters the pump through this inlet. The pump can be of a centrifugal design for high speeds, or an axial flow pump for low to medium speeds. The water pressure inside the inlet is increased by the pump ...
The term inert gas is context-dependent because several of the inert gases, including nitrogen and carbon dioxide, can be made to react under certain conditions. [1] [2] Purified argon gas is the most commonly used inert gas due to its high natural abundance (78.3% N 2, 1% Ar in air) [3] and low relative cost.
Chemists remove gases from solvents when the compounds they are working on are possibly air- or oxygen-sensitive (air-free technique), or when bubble formation at solid-liquid interfaces becomes a problem. The formation of gas bubbles when a liquid is frozen can also be undesirable, necessitating degassing beforehand.