Search results
Results from the WOW.Com Content Network
The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [ 27 ] [ 33 ] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry.
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
Though .38 Special and .357 Magnum would seem to be different diameter chamberings, they are in fact identical, as at 0.357 inches (9.07 mm), they both have the same bullet diameter. The .38 Special nomenclature relates to the previous use of heeled bullets (such as the .38 Short Colt and .38 Long Colt ), which were the same diameter as the case.
The English pronunciation with /ks/ is unetymological, contrary to the historical value of the letter x (/ʃ/) in Spanish orthography. Alternative etymologies of the name advanced in the late 19th century connected the name Texas with the Spanish word teja , meaning 'roof tile', the plural tejas being used to designate Indigenous Pueblo ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used. deck screw: Similar to drywall screw, except that it has improved corrosion resistance and is generally supplied in a larger gauge. Most deck screws have a type-17 (auger type) thread-cutting tip for installation into decking ...