Search results
Results from the WOW.Com Content Network
A thermal switch (sometimes thermal reset or thermal cutout (TCO)) is a device which normally opens at a high temperature (often with a faint "plink" sound) and re-closes when the temperature drops. The thermal switch may be a bimetallic strip , often encased in a tubular glass bulb to protect it from dust or short circuit .
For instance, setting those up so that the temperature in the morning at 7 a.m. should be 21 °C (69.8 °F), makes sure that at that time the temperature will be 21 °C (69.8 °F), where a conventional thermostat would just start working at that time.
Full-tower computer cases may contain multiple cooling fans. At the top of the case is a fan controller. Fan control is the management of the rotational speed of an electric fan.
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
A hot water reset control loop measures the outside air temperature; this information is used to estimate demand or heating load as the outdoor temperature varies. The supply hot water temperature is modulated up and down range in an inverse linear ratio to outside air temperature. The typical range for conventional boilers is to vary the ...
Amazon told her to speak with Integrity about it; Integrity told her to speak with Amazon. What Branch believed to be her long-awaited promotion turned out to be her layoff, she said. Antonio Miller was a temp at the Chester facility in 2013, after graduating from Radford University with a bachelor's degree in political science.
A finned air cooled heatsink with fan clipped onto a CPU, with a smaller passive heatsink without fan in the background A 3-fan heatsink mounted on a video card to maximize cooling efficiency of the GPU and surrounding components Commodore 128DCR computer's switch-mode power supply, with a user-installed 60 mm cooling fan.
A hot water dispenser which keeps water hot in a tank uses the energy needed to heat the water to the required temperature and wastes the energy needed to keep the water hot permanently in a thermally-insulated tank when not being used. These tank type dispensers often also consists of energy wasting 'keep warm' and 'reboil' functions.