Search results
Results from the WOW.Com Content Network
Behringer is an audio equipment company founded by the Swiss engineer Uli Behringer on 25 January 1989 in Willich, Germany. Behringer produces equipment including synthesizers, mixers, audio interfaces and amplifiers. Behringer is owned by Music Tribe (formerly Music Group), a holding company chaired by Uli Behringer. [1]
A Sony PCM-501ES EIAJ LPCM Adapter on a Sony SL-HF360 VTR. The Sony PCM-1600 was the first commercial video-based 16-bit recorder. The 1600 (and its later versions, the 1610 and 1630) used special U-matic-format VCRs also furnished by Sony for transports, such as the BVU-200B (the first model of VCR optimized to work, and sold with, the PCM-1600 in 1979), [2] BVU-800DA, VO-5630DA, and the ...
A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...
A single amplifier can usually power a woofer and a tweeter only through a post-amplifier crossover filter, which protects each driver from signals outside its frequency range. Bi-amping of speakers requires double the channels of amplification and can be accomplished using two ordinary amplifiers in either a vertical or horizontal arrangement.
As long as the impedances are balanced, noise will couple equally into the two wires (and be rejected by a differential amplifier), regardless of the signal that is present on them. [ 1 ] [ 2 ] A simple method of driving a balanced line is to inject the signal into the "hot" wire through a known source impedance , and connect the "cold" wire to ...
SSL SL9000J (72 channel) console at Cutting Room Recording Studio, NYC An audio engineer adjusts a mixer while doing live sound for a band.. A mixing console or mixing desk is an electronic device for mixing audio signals, used in sound recording and reproduction and sound reinforcement systems.
The high-gain input is routed through a pad (attenuator). An amp may also have a low-gain input, which is unattenuated, for regular basses. Lower-priced amps may have a preamp out. Bass amps intended for use by professional players may have an XLR DI output so that the amp can be connected directly to a mixing board of a PA system or recording ...
Another alternative are powered speakers with an amplifier built into the speaker enclosure. Since the amplifier is at the same location as the speaker, the speaker requires only a line level audio signal as an input. Line level signals are typically around 1-2 volts, and can be transmitted over much smaller cable (typically 20-26 AWG).