Search results
Results from the WOW.Com Content Network
Cable lacing is a method for tying wiring harnesses and cable looms, traditionally used in telecommunication, naval, and aerospace applications. This old cable management technique, taught to generations of lineworkers , [ 1 ] is still used in some modern applications since it does not create obstructions along the length of the cable, avoiding ...
Figure parts A–D show steps in forming a "short tie" Western Union splice. Figure parts E and F show two possible "long tie" variations. [2]The Western Union splice or lineman splice is a method of joining electrical cable, developed in the nineteenth century during the introduction of the telegraph and named for the Western Union telegraph company.
Shrouded cable glands going into a flow meter. Split cable gland KVT for routing pre-terminated cables. A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]
The conduit methods were known to be of better quality, but cost significantly more than K&T. [2] In 1909, flexible armored cable cost about twice as much as K&T, and conduit cost about three times the price of K&T. [6] Knob and tube wiring persisted since it allowed owners to wire a building for electricity at lower cost.
If a cable is straight coiled and then pulled from the coil, it has the effect as coiling cable on a spool and then pulling the cable off the top of the spool, imparting a twist in the cable with every coil that is removed. To make it lie flat, the twist will need to be removed. The advantages of straight coiling cable are that it will not ...
Assortment of cable ties. A cable tie (also known as a hose tie, panduit, [1] tie wrap, wire tie, zap-straps, or zip tie) is a type of fastener for holding items together, primarily electrical cables and wires. Because of their low cost, ease of use, and binding strength, cable ties are ubiquitous, finding use in a wide range of other applications.
To tie: Create a loop in the rope. Then pull a bight of the working part through the loop, creating an overhand noose knot. Pull another bight of the working part through the loop of the previous stitch. Tighten the stitch to the desired degree by pulling on both sides of the loop.
Splices are preferred to knotted rope, since while a knot typically reduces the strength by 20–40%, [2] a splice is capable of attaining a rope's full strength. [3] However, splicing usually results in a thickening of the line and, if subsequently removed, leaves a distortion of the rope.