Search results
Results from the WOW.Com Content Network
The intersection of a UTM zone and a latitude band is (normally) a 6° × 8° polygon called a grid zone, whose designation in MGRS is formed by the zone number (one or two digits – the number for zones 1 to 9 is just a single digit, according to the example in DMA TM 8358.1, Section 3-2, [1] Figure 7), followed by the latitude band letter ...
The Universal Transverse Mercator (UTM) is a map projection system for assigning coordinates to locations on the surface of the Earth.Like the traditional method of latitude and longitude, it is a horizontal position representation, which means it ignores altitude and treats the earth surface as a perfect ellipsoid.
The difference between grid north and true north is very small and can be ignored for most navigation purposes. The difference exists because the correspondence between a flat map and the round Earth is necessarily imperfect. At the South Pole, grid north conventionally points northwards along the Prime Meridian. [9]
UTM does not have a latitude zone! It is made up of the UTM Zone (1-60) N or S for North or South Hemisphere and 6 figures for Eastings with 7 figures for Northings to define a 1 metre square. What is in this wiki report is not the standard for UTM but is just adding to the confusion caused by mixing MGRS with UTM.
Under the Chairman of the Joint Chiefs of Staff Instruction CJCSI 3900.01C dated 30 June 2007, GARS was adopted for use by the US DoD as "the “area-centric” counterpart to the “point-centric” MGRS". It uses the WGS 1984 Datum and is based on lines of longitude (LONG) and latitude (LAT). It is intended to provide an integrated common ...
(modern) UTM – Universal Transverse Mercator: Is a discretization of the continuous UTM grid, with a kind of 2-level hierarchy, where the first level (coarse grain) correspond to the "UTM zones with latitude bands" (the MGRS ), use the same 60 cylinders as reference-projection objects.
[20] [21] The six-degree zone width of UTM strikes a balance between the frequency of these discontinuities versus distortion of scale, which would increase unacceptably if the zones were made wider. (UTM further uses a 0.9996 scale factor at the central meridian, growing to 1.0000 at two meridians offset from the center, and increasing toward ...
The universal polar stereographic (UPS) coordinate system is used in conjunction with the universal transverse Mercator (UTM) coordinate system to locate positions on the surface of the Earth. Like the UTM coordinate system, the UPS coordinate system uses a metric-based cartesian grid laid out on a conformally projected surface.