Search results
Results from the WOW.Com Content Network
Setting the line consists of anchoring one end to one side of the channel, then taking the line out to the other side, baiting the hooks while this is being done. Trees or rocks make good anchor points for trotlines, but attention should be given that the line is not tied around rough or sharp edges that might cut through the line.
On a square-rigged ship, a bowline (sometimes spelled as two words, bow line) is a rope that holds the edge of a square sail towards the bow of the ship and into the wind, preventing it from being taken aback. [8] A ship is said to be on a "taut bowline" when these lines are made as taut as possible in order to sail close-hauled to the wind. [9]
The water bowline is a type of knot designed for use in wet conditions where other knots may slip or jam.. Although similar in finished appearance to the double bowline, the water bowline is formed with a clove hitch as the loop in the standing part of the rope.
Soft body swimbaits have several sub-categories including paddle tails, line through, and top hook swimbaits. Paddle tail swimbaits are by far the most common swimbait many anglers use. These baits come in an array of sizes with the smaller sizes often being used as a trailer for a spinnerbait , chatterbait or underspin.
The basic rode system is a line, cable, or chain several times longer than the depth of the water running from the anchor to the mooring buoy, the longer the rode is the shallower the angle of force on the anchor (it has more scope). A shallower scope means more of the force is pulling horizontally so that ploughing into the substrate adds ...
A casting net, also called a throw net, is a net used for fishing. It is a circular net with small weights distributed around its edge. The net is cast or thrown by hand in such a manner that it spreads out while it's in the air before it sinks into the water. This technique is called net casting or net throwing.
Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.
See anchor block. bond The adhesion of concrete or grout to prestressing strands, wires or bars, or to unstressed reinforcement, either through friction or mechanical interlock. [1]: 9 bond strength The resistance to separation of hardened concrete or grout from prestressing strands, wires or bars, or from unstressed reinforcement.