Search results
Results from the WOW.Com Content Network
Resistive random-access memory (ReRAM or RRAM) is a type of non-volatile (NV) random-access (RAM) computer memory that works by changing the resistance across a dielectric solid-state material, often referred to as a memristor. One major advantage of ReRAM over other NVRAM technologies is the ability to scale below 10 nm.
In fact, rather than the Williams tube memory being designed for the Baby, the Baby was a testbed to demonstrate the reliability of the memory. [8] [9] Magnetic-core memory was invented in 1947 and developed up until the mid-1970s. It became a widespread form of random-access memory, relying on an array of magnetized rings.
Those who required real RAM-like performance and non-volatility typically have had to use conventional RAM devices and a battery backup. For example, IBM PC's and successors beginning with the IBM PC AT used nonvolatile BIOS memory, often called CMOS RAM or parameter RAM, and this was a common solution in other early microcomputer systems like ...
The memory cells are laid out in rectangular arrays on the surface of the chip. The 1-bit memory cells are grouped in small units called words which are accessed together as a single memory address. Memory is manufactured in word length that is usually a power of two, typically N=1, 2, 4 or 8 bits.
Probably the biggest challenge for phase-change memory is its long-term resistance and threshold voltage drift. [34] The resistance of the amorphous state slowly increases according to a power law (~t 0.1). This severely limits the ability for multilevel operation, since a lower intermediate state would be confused with a higher intermediate ...
The main determinant of a memory system's cost is the density of the components used to make it up. Smaller components, and fewer of them, mean that more "cells" can be packed onto a single chip, which in turn means more can be produced at once from a single silicon wafer.
Ferroelectric RAM (FeRAM, F-RAM or FRAM) is a form of random-access memory similar in construction to DRAM, both use a capacitor and transistor but instead of using a simple dielectric layer the capacitor, an F-RAM cell contains a thin ferroelectric film of lead zirconate titanate [Pb(Zr,Ti)O 3], commonly referred to as PZT. The Zr/Ti atoms in ...
Ferroelectric RAM (FeRAM, F-RAM or FRAM) is a random-access memory similar in construction to DRAM but using a ferroelectric layer instead of a dielectric layer to achieve non-volatility. FeRAM is one of a growing number of alternative non-volatile random-access memory technologies that offer the same functionality as flash memory .