Search results
Results from the WOW.Com Content Network
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
Geographic coordinate conversion has applications in cartography, surveying, navigation and geographic information systems . In geodesy, geographic coordinate conversion is defined as translation among different coordinate formats or map projections all referenced to the same geodetic datum. [ 1] A geographic coordinate transformation is a ...
The mile (Mil) is thus about 963 or 1146 meters (3160 or 3760 ft) — approximately six or seven tenths of a mile, and significantly shorter than the modern statute or land mile of 5280 ft or 1760 yd (approximately 1.6 km). The precise width of the etzba (finger) has been a subject of controversy among halakhic authorities. The best known are ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
For petroleum gases, the standard cubic foot (scf) is defined as one cubic foot of gas at 60 °F (288.7 K; 15.56 °C) and at normal sea level air pressure. The pressure definition differs between sources, but are all close to normal sea level air pressure. A pressure of 14.696 pounds per square inch (1.00000 atm; 101.325 kPa). [2]
Height above mean sea level is a measure of a location's vertical distance (height, elevation or altitude) in reference to a vertical datum based on a historic mean sea level. In geodesy, it is formalized as orthometric height. The zero level varies in different countries due to different reference points and historic measurement periods.
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.
The principal unit of land measure is 甲 ( Taiwanese Hokkien: kah, Hakka: kap, Mandarin: jiǎ). The unit is derived from the obsolete Dutch morgen, which was introduced during Taiwan's Dutch era. In the later era Kingdom of Tungning, 犁 ( Taiwanese Hokkien: lê, Hakka: lài, Mandarin: lí) is defined to represent the area that could be farmed ...