enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Capacity credit - Wikipedia

    en.wikipedia.org/wiki/Capacity_credit

    The capacity credit can be much lower than the capacity factor (CF): in a not very probable scenario, if the riskiest time for the power system is after sunset, the capacity credit for solar power without coupled energy storage is zero regardless of its CF [3] (under this scenario all existing conventional power plants would have to be retained after the solar installation is added).

  3. Pumped-storage hydroelectricity - Wikipedia

    en.wikipedia.org/wiki/Pumped-storage...

    Pumped storage is by far the largest-capacity form of grid energy storage available, and, as of 2020, accounts for around 95% of all active storage installations worldwide, with a total installed throughput capacity of over 181 GW and as of 2020 a total installed storage capacity of over 1.6 TWh.

  4. Capacity factor - Wikipedia

    en.wikipedia.org/wiki/Capacity_factor

    Solar PV and wind turbines have a capacity factor limited by the availability of their "fuel", sunshine and wind respectively. A hydroelectricity plant may have a capacity factor lower than 100% due to restriction or scarcity of water, or its output may be regulated to match the current power need, conserving its stored water for later usage.

  5. Nameplate capacity - Wikipedia

    en.wikipedia.org/wiki/Nameplate_capacity

    Nameplate capacity, also known as the rated capacity, nominal capacity, installed capacity, maximum effect or gross capacity, [1] is the intended full-load sustained output of a facility such as a power station, [2] [3] electric generator, a chemical plant, [4] fuel plant, mine, [5] metal refinery, [6] and many others.

  6. Power rating - Wikipedia

    en.wikipedia.org/wiki/Power_rating

    For AC-operated devices (e.g. coaxial cable, loudspeakers), there may even be two power ratings, a maximum (peak) power rating and an average power rating. [ 5 ] [ 6 ] For such devices, the peak power rating usually specifies the low frequency or pulse energy, while the average power rating limits high-frequency operation. [ 5 ]

  7. State of charge - Wikipedia

    en.wikipedia.org/wiki/State_of_charge

    State of charge (SoC) quantifies the remaining capacity available in a battery at a given time and in relation to a given state of ageing. [1] It is usually expressed as percentage (0% = empty; 100% = full). An alternative form of the same measure is the depth of discharge , calculated as 1 −

  8. List of battery sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_battery_sizes

    LiFePO4 3.2 V. Slightly taller version of the 38120 cells, most often used in electric bikes. Height including the screw terminals: 154 mm [citation needed] 40152: 40152s 15,000 40: 152 LiFePO4 3.2 V. Largest cylindrical LiFePO4 cells. Height including the screw terminals: 167 mm [citation needed] 4680: 46800 [citation needed] 9,000 [citation ...

  9. Nominal power (photovoltaic) - Wikipedia

    en.wikipedia.org/wiki/Nominal_power_(photovoltaic)

    The nominal power of PV devices is measured under standard test conditions (STC), specified in standards such as IEC 61215, IEC 61646 and UL 1703. Specifically, the light intensity is 1000 W/m 2, with a spectrum similar to sunlight hitting the Earth's surface at latitude 35°N in the summer (airmass 1.5), the temperature of the cells being 25 °C.