Search results
Results from the WOW.Com Content Network
Steam locomotives consume vast quantities of water because they operate on an open cycle, expelling their steam immediately after a single use rather than recycling it in a closed loop as stationary and marine steam engines do. Water was a constant logistical problem, and condensing engines were devised for use in desert areas.
Traction engine. A traction engine is a steam-powered tractor used to move heavy loads on roads, plough ground or to provide power at a chosen location. The name derives from the Latin tractus, meaning 'drawn', since the prime function of any traction engine is to draw a load behind it.
A steam locomotive from East Germany. This class of engine was built in 1942–1950 and operated until 1988. A steam engine is a heat engine that performs mechanical work using steam as its working fluid. The steam engine uses the force produced by steam pressure to push a piston back and forth inside a cylinder.
Horizontal tubular vessel, strong enough to contain high-pressure steam in a harsh working environment; closed at either end by the firebox and tube plate. Usually well filled with water but with space for steam – produced by heat from the firebox and boiler tubes – to be above the water surface. [1][2][5][3]: 9.
Articulated locomotive. An articulated locomotive is a steam locomotive (rarely, an electric locomotive) with one or more engine units that can move independently of the main frame. Articulation allows the operation of locomotives that would otherwise be too large to negotiate a railroad's curves, whether mainlines or special lines with extreme ...
Factor of adh. The Union Pacific Big Boy is a type of simple articulated 4-8-8-4 steam locomotive manufactured by the American Locomotive Company (ALCO) between 1941 and 1944 and operated by the Union Pacific Railroad in revenue service until 1962. The 25 Big Boy locomotives were built to haul freight over the Wasatch Range between Ogden, Utah ...
Steam locomotives constructed in the 21st century fall into two broad categories: those that use advanced steam technology to be commercially competitive with diesels; and those built to more traditional designs for hauling tourist trains. Even locomotives in the second case likely use some modern methods and materials.
Reversing lever. This is the most common form of reverser. It is also known as a Johnson bar in the United States. It consists of a long lever mounted parallel to the direction of travel, on the driver’s side of the cab. It has a handle and sprung trigger at the top and is pivoted at the bottom to pass between two notched sector plates.