Search results
Results from the WOW.Com Content Network
A slipped half hitch [1] [2] is a knot in which the weight of the load the rope carries depresses the loop sufficiently to keep it in place until the load item is placed in its location. When no longer required the free end may be pulled and draw the loop through and so release the load.
Form an overhand noose, or simply tie an overhand knot around the standing part as shown. Tighten the overhand portion of the knot around the standing part. Thread the working part through the loop. First close the noose on the working part by pulling on the standing part, then remove any remaining slack in the knot by pulling on the working part.
The overhand loop is a simple knot which forms a fixed loop in a rope. Made by tying an overhand knot in the bight, it can be tied anywhere along a rope (does not need any working end). The knot can be used for attaching clips, hooks, other rope, etc., but has the disadvantage that it is likely to jam tight when the rope has been pulled and the ...
Egg loop a.k.a. bumper knot – secures soft or loose bait in fishing applications; Elusive knot Englishman's knot (fisherman's knot) – a bend consisting of two overhand knots, each tied around the standing part of the other; Eskimo bowline – places a loop in the end of a rope; Eskimo bowstring loop knot
Below is a basic method of tying. The knot can also be made by using the rod itself to form the loop, but the tying method does not affect the performance of the resulting hitch. Begin with an overhand loop, that is, a loop in which the working part passes over the standing part:
In reference to knots, loop may refer to: One of the fundamental structures used to tie knots. Specifically, it is a U-form narrower than a bight. [17] A type of knot used to create a closed circle in a line. A loop is one of the fundamental structures used to tie knots. It is a full circle formed by passing the working end of a rope over itself.
Zeppelin bend forming a loop: the four stages of the method starting with a "clover leaf" or flattened overhand knot; Red line: ends of the overhand knot, Green line: ends of the underhand. Another method of remembering this knot is to visualize a "69". To tie the knot with this method, follow the steps below: Make a "6" with one line (rope) end.
A stopper knot (or simply stopper) is a knot that creates a fixed thicker point on an otherwise-uniform thickness rope for the purpose of preventing the rope, at that point, from slipping through a narrow passage, such as a hole in a block. To pass a rope through a block, or hole, is to reeve it. To pull it out is to unreeve it.