Search results
Results from the WOW.Com Content Network
However, this gain is not without a downside. Large packets occupy a link for more time than a smaller packet, causing greater delays to subsequent packets, and increasing network delay and delay variation. For example, a 1500-byte packet, the largest allowed by Ethernet at the network layer, ties up a 14.4k modem for about one second.
In the seven-layer OSI model of computer networking, packet strictly refers to a protocol data unit at layer 3, the network layer. [2] A data unit at layer 2, the data link layer, is a frame. In layer 4, the transport layer, the data units are segments and datagrams.
In computer networking, a flit (flow control unit or flow control digit) is a link-level atomic piece that forms a network packet or stream. [1] The first flit, called the header flit holds information about this packet's route (namely the destination address) and sets up the routing behavior for all subsequent flits associated with the packet.
This may require breaking large protocol data units or long data streams into smaller chunks called "segments", since the network layer imposes a maximum packet size called the maximum transmission unit (MTU), which depends on the maximum packet size imposed by all data link layers on the network path between the two hosts. The amount of data ...
When a packet (network layer PDU) [note 1] of n bytes arrives, n tokens are removed from the bucket, and the packet is sent to the network. If fewer than n tokens are available, no tokens are removed from the bucket, and the packet is considered to be non-conformant. This can be compared with the leaky bucket, repeated from above:
The ITU-T G.hn standard, which provides a way to create a high-speed (up to 1 Gigabit/s) Local area network using existing home wiring (power lines, phone lines and coaxial cables), is an example of a protocol that employs packet aggregation to increase efficiency.
Single connections will have guaranteed in order packet delivery and will transmit at the speed of a single NIC. [14] This mode provides load balancing and fault tolerance. Broadcast (broadcast) Transmit network packets on all slave network interfaces. This mode provides fault tolerance. IEEE 802.3ad Dynamic link aggregation (802.3ad, LACP)
End nodes in IPv6 are expected to perform Path MTU Discovery to determine the maximum size of packets to send, and the upper-layer protocol is expected to limit the payload size. If the upper-layer protocol is unable to do so, the sending host may use the Fragment extension header instead. Any data link layer conveying IPv6 data must be capable ...