Search results
Results from the WOW.Com Content Network
Though bituminous coal varies in its chemical composition, a typical composition is about 84.4% carbon, 5.4% hydrogen, 6.7% oxygen, 1.7% nitrogen, and 1.8% sulfur, on a weight basis. [11] Its bank density (the density of a coal seam prior to breaking up during mining) is about 1346 kg/m 3 (84 lb/ft 3) while the bulk density of extracted coal is ...
The density of the coal seam is necessary for conversion of resources into reserves. Relative density is normally determined by the loss of a sample's weight in water. This is best achieved using finely ground coal, as bulk samples are quite porous.
The kilogram per cubic metre (symbol: kg·m −3, or kg/m 3) is the unit of density in the International System of Units (SI). It is defined by dividing the SI unit of mass, the kilogram, by the SI unit of volume, the cubic metre. [1]
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
For example, in the brewing industry, the Plato table lists sucrose concentration by weight against true SG, and was originally (20 °C/4 °C) [7] i.e. based on measurements of the density of sucrose solutions made at laboratory temperature (20 °C) but referenced to the density of water at 4 °C which is very close to the temperature at which ...
The energy density of coal is roughly 24 megajoules per kilogram [80] (approximately 6.7 kilowatt-hours per kg). For a coal power plant with a 40% efficiency, it takes an estimated 325 kg (717 lb) of coal to power a 100 W lightbulb for one year.
The calorific value Q of coal [kJ/kg] is the heat liberated by its complete combustion with oxygen. Q is a complex function of the elemental composition of the coal [citation needed]. Q can be determined experimentally using calorimeters. Dulong suggests the following approximate formula for Q when the oxygen content is less than 10%:
Lignite mining, western North Dakota, US (c. 1945). Lignite is brownish-black in color and has a carbon content of 60–70 percent on a dry ash-free basis. However, its inherent moisture content is sometimes as high as 75 percent [1] and its ash content ranges from 6–19 percent, compared with 6–12 percent for bituminous coal. [5]