Search results
Results from the WOW.Com Content Network
The core of a building is often placed in the center of a building, but it can also be placed on a side of a building, and there can be several cores in a building. Cores on a side of a building are known as perimeter cores, are completely inside the building and can allow for more uninterrupted, column-free floor space within a building.
A shaft equipped with ladder rungs for personnel access. In civil engineering a shaft is an underground vertical or inclined passageway. Shafts are often entered through a manhole and closed by a manhole cover. They are constructed for a number of reasons including: For the construction of a tunnel
The following other wikis use this file: Usage on en.wikisource.org Index:US Code Section 1.pdf; Page:US Code Section 1.pdf/1; Page:US Code Section 1.pdf/2
This is an incomplete list of DIN standards.. The "STATUS" column gives the latest known status of the standard.. If a standard has been withdrawn and no replacement specification is listed, either the specification was withdrawn without replacement or a replacement specification could not be identified.
Mechanical floors are generally counted in the building's floor numbering (this is required by some building codes) but are accessed only by service elevators. Some zoning regulations exclude mechanical floors from a building's maximum area calculation, permitting a significant increase in building sizes; this is the case in New York City. [1]
The Uniform Mechanical Code (UMC) is a model code developed by the International Association of Plumbing and Mechanical Officials to govern the installation, inspection and maintenance of HVAC (heating, ventilating and air-conditioning) and refrigeration systems. It is designated as an American National Standard.
In 1921 the Building Code Committee and in 1925 a report was issued titled "Recommended Practice for Arrangement of Building Codes" which consisted of 19 chapters, including Chapter 15 on plumbing. This report was known informally as the "Hoover Code" as it was issued under the signature of the Secretary of Commerce Herbert Hoover.
Gudgeons on the end of a shaft, A & B. A winged gudgeon is one that has extensions that increase its ability to adhere to the fixed surface. At the beginning of the Industrial Revolution, winged gudgeons were used to support water wheel shafts, [2] and later, steam engine shafts.