Search results
Results from the WOW.Com Content Network
Levels of evapotranspiration in a given area are primarily controlled by three factors: [10] Firstly, the amount of water present. Secondly, the amount of energy present in the air and soil (e.g. heat, measured by the global surface temperature ); and thirdly the ability of the atmosphere to take up water ( humidity ).
Two major factors influence the rate of water flow from the soil to the roots: the hydraulic conductivity of the soil and the magnitude of the pressure gradient through the soil. Both of these factors influence the rate of bulk flow of water moving from the roots to the stomatal pores in the leaves via the xylem. [7]
Various forms of crop coefficients (K c) account for differences between specific vegetation modeled and a reference evapotranspiration (RET or ET 0) standard. Stress coefficients (K s) account for reductions in ET due to environmental stress (e.g. soil saturation reduces root-zone O 2, low soil moisture induces wilt, air pollution effects, and ...
Crop coefficients are properties of plants used in predicting evapotranspiration (ET). The most basic crop coefficient, K c, is simply the ratio of ET observed for the crop studied over that observed for the well calibrated reference crop under the same conditions.
It is a steel container 1.83 m (6 ft) on a side and 0.61 m (2 ft) deep, sunk into the ground with an above-ground rim of 7.6–10 centimetres (3.0–3.9 in) and is painted black internally. Its evaporation rate is lower than the Class A pan and conversion factors must be used. [8]
When water evaporates, it takes up energy from its surroundings and cools the environment. When it condenses, it releases energy and warms the environment. These heat exchanges influence the climate system. The evaporative phase of the cycle purifies water because it causes salts and other solids picked up during the cycle to be left behind.
The Penman equation describes evaporation (E) from an open water surface, and was developed by Howard Penman in 1948. Penman's equation requires daily mean temperature, wind speed, air pressure, and solar radiation to predict E. Simpler Hydrometeorological equations continue to be used where obtaining such data is impractical, to give comparable results within specific contexts, e.g. humid vs ...
Monthly estimated potential evapotranspiration and measured pan evaporation for two locations in Hawaii, Hilo and Pahala. Potential evapotranspiration is usually measured indirectly, from other climatic factors, but also depends on the surface type, such as free water (for lakes and oceans), the soil type for bare soil, and also the density and diversity of vegetation.