Search results
Results from the WOW.Com Content Network
To determine the actual size and features of a disk, the DEVICE_CONFIGURATION_IDENTIFY command is used, and the output of this command can be compared to the output of IDENTIFY_DEVICE to see if a DCO is present on a given hard drive. Most major tools will remove the DCO in order to fully image a hard drive, using the DEVICE ...
A modern PC is configured to attempt to boot from various devices in a certain order. If a computer is not booting from the device desired, such as the floppy drive, the user may have to enter the BIOS Setup function by pressing a special key when the computer is first turned on (such as Delete, F1, F2, F10 or F12), and then changing the boot order. [6]
On the original IBM PC and XT, if no bootable disk was found, the BIOS would try to start ROM BASIC with the interrupt call to interrupt 18h. Since few programs used BASIC in ROM, clone PC makers left it out; then a computer that failed to boot from a disk would display "No ROM BASIC" and halt (in response to interrupt 18h).
The boot partition (or boot volume) [5] is the disk partition that contains the operating system folder, known as the system root or %systemroot% in Windows NT. [6]: 174 Before Windows 7, the system and boot partitions were, by default, the same and were given the "C:" drive letter.
If the boot order is set to "first, the DVD drive; second, the hard disk drive", then the firmware will try to boot from the DVD drive, and if this fails (e.g. because there is no DVD in the drive), it will try to boot from the local hard disk drive. For example, on a PC with Windows installed on the hard drive, the user could set the boot ...
Most computers have a reset line that brings the device into the startup state and is active for a short time after powering on. For example, in the x86 architecture, asserting the RESET line halts the CPU; this is done after the system is switched on and before the power supply has asserted "power good" to indicate that it is ready to supply ...
Control Panel has been part of Microsoft Windows since Windows 1.0, [1] with each successive version introducing new applets. Beginning with Windows 95, the Control Panel is implemented as a special folder, i.e. the folder does not physically exist, but only contains shortcuts to various applets such as Add or Remove Programs and Internet Options.
Once all the boot and system drivers have been loaded, the kernel starts the session manager (smss.exe), which begins the login process. After the user has successfully logged into the machine, winlogon applies User and Computer Group Policy setting and runs startup programs declared in the Windows Registry and in "Startup" folders. [5]