enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. File:PRINCE2 Process Model Diagram.pdf - Wikipedia

   en.wikipedia.org/wiki/File:PRINCE2_Process_Model...

   Original file (1,754 × 1,239 pixels, file size: 25 KB, MIME type: application/pdf) This is a file from the Wikimedia Commons . Information from its description page there is shown below.

3. File:Durham tube diagram.jpg - Wikipedia

   en.wikipedia.org/wiki/File:Durham_tube_diagram.jpg

   Durham_tube_diagram.jpg (158 × 592 pixels, file size: 26 KB, MIME type: image/jpeg) This is a file from the Wikimedia Commons . Information from its description page there is shown below.

4. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

5. Plumbing drawing - Wikipedia

   en.wikipedia.org/wiki/Plumbing_drawing

   In shop drawings pipe sizes should be marked with the text and size should be shown with double line. Each pipes with different purposes will be displayed with different colors for ease of understanding. Drainage pipes should be shown with slope. For water supply, pump capacity and number of pumps will be attached as drawing file.

6. Image conversion - Wikipedia

   en.wikipedia.org/wiki/Image_conversion

   RAW is not a standardized format, in fact, RAW-formats even differ between camera models from the same vendor [citation needed]. Data in a RAW-file is structured according to the Bayer filter's pattern in cameras that use a single image sensor. Debayering, the process of obtaining bitmap data from a RAW-image is always a lossy operation.

7. Hydraulic diameter - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_diameter

   For the limiting case of a very wide duct, i.e. a slot of width b, where b ≫ a, and a is the water depth, then D H = 4a. For a fully filled duct or pipe whose cross-section is a convex regular polygon , the hydraulic diameter is equivalent to the diameter D {\displaystyle D} of a circle inscribed within the wetted perimeter .