Search results
Results from the WOW.Com Content Network
These are a measure of the standardized length of the barrel versus the rifled bore of the barrel. In other words, a 12/45 is 12"×45= the length of the rifled bore of that gun in inches. This explains the differences in both penetration and long range performance of various naval rifles over the years.
For example on an AR-type rifle, the mil-spec distance from center of bore to top of rail is 1.211 inches, or approximately 31 mm (1.2 in). The mount height itself, that is the distance from the top of rail to center of scope, varies, but typically lies around 36–38 mm (1.4–1.5 in) (higher and lower mounts are also readily available).
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
Chamber illustration indicating the various sections of a typical rifle chamber. The freebore is the cyan colored section just ahead of the neck. In firearms, freebore (also free-bore, free bore, or throat) is the portion of the gun barrel between the chamber and the rifled section of the barrel bore. The freebore is located just forward of the ...
Gunsmiths may adjust the length of pull of custom-built firearms or older firearms by cutting off a portion of the buttstock or adding a recoil pad to the buttstock. [3] Some sources [ 1 ] [ 4 ] suggest a shooter's optimum length of pull will allow the butt of the firearm to exactly reach the inside of the elbow when the hand of that arm grips ...
The British standard ordnance weights and measurements for the artillery were established by the Master General of Ordnance in 1764, and these were not altered until 1919, [citation needed] when the metric system was additionally introduced.
The shank length is not always the same at the thread length, which is the case if the insert has a threadless portion (sub-shank) Tenon designates the thread length; Shoulder designates the barrel diameter in front of the thread portion; Unless otherwise mentioned, right hand threads are assumed. Left hand threads are designated "LH".
Since barrel length is limited by practical concerns to about arm's length for a rifle and much shorter for a handgun, increasing bore diameter is the normal way to increase the efficiency of a cartridge. The limit to bore diameter is generally the sectional density of the projectile (see external ballistics).