Search results
Results from the WOW.Com Content Network
Each of the formulas listed in the tables assumes that the roughness profile has been filtered from the raw profile data and the mean line has been calculated. The roughness profile contains n {\displaystyle n} ordered, equally spaced points along the trace, and y i {\displaystyle y_{i}} is the vertical distance from the mean line to the i th ...
A standard one-inch micrometer has readout divisions of 0.001 inch and a rated accuracy of ±0.0001 inch [15] ("one tenth", in machinist parlance). Both the measuring instrument and the object being measured should be at room temperature for an accurate measurement; dirt, operator skill issue, and misuse (or abuse) of the instrument are the ...
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
To handle these, Module:Convert/makeunits includes a specials table that adds an "alttype" (alternate type) field to certain whitelisted units. The alttype field allows conversion between units of different type, provided each unit is whitelisted to allow the conversion.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
In the cases where non-SI units are used, the numerical calculation of a formula can be done by first working out the factor, and then plug in the numerical values of the given/known quantities. For example, in the study of Bose–Einstein condensate , [ 6 ] atomic mass m is usually given in daltons , instead of kilograms , and chemical ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
The miner's inch is a method of measuring the amount of flow a particular water supply system (such as a flume or sluice) is capable of supplying. The miner ’s inch measures the amount of water that would flow through a slot of a given area at a given pressure (for example, at a head of 6 inches of water , or 1.5 kPa .)