Search results
Results from the WOW.Com Content Network
Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]
Multi-material injection molding (MMM) is the process of molding two or more different materials into one plastic part at one time. [1] As is the case in traditional injection molding, multi material injection molding uses materials that are at or near their melting point so that the semi-liquidous material can fill voids and cavities within a pre-machined mold, thus taking on the desired ...
This projected area is multiplied by a clamp force of from 1.8 to 7.2 tons for each square centimetre of the projected areas. As a rule of thumb, 4 or 5 tons/in 2 can be used for most products. If the plastic material is very stiff, it requires more injection pressure to fill the mould, and thus more clamp tonnage to hold the mould closed.
The two main gate systems are manually trimmed gates and automatically trimmed gates. The following examples show where they are used: Sprue gate: Used for large components, the gate mark is visible in component and no runner is required. e.g.: bucket molding (backside cylindrical gate mark visible and can be felt).
Transfer molding (BrE: transfer moulding) is a manufacturing process in which casting material is forced into a mold. Transfer molding is different from compression molding in that the mold is enclosed [ 1 ] rather than open to the fill plunger resulting in higher dimensional tolerances and less environmental impact. [ 2 ]
Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...
A bead is typically a rounded shape cut into a square edge to soften the edge and provide some protection against splitting. Beads can be simple round shapes, or more complex patterns. A bead may be created with an electric router , a special moulding handplane [ 1 ] or a scratch stock . [ 2 ]
A building's surface detailing, inside and outside, often includes decorative moulding, and these often contain ogee-shaped profiles—consisting (from low to high) of a concave arc flowing into a convex arc, with vertical ends; if the lower curve is convex and higher one concave, this is known as a Roman ogee, although frequently the terms are used interchangeably and for a variety of other ...