Search results
Results from the WOW.Com Content Network
A voltmeter is an instrument used for measuring electric potential difference between two points in an electric circuit. It is connected in parallel . It usually has a high resistance so that it takes negligible current from the circuit.
Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
Multimeter: General purpose instrument measures voltage, current and resistance (and sometimes other quantities as well) Network analyzer: Measures network parameters Ohmmeter: Measures the resistance of a component Oscilloscope: Displays waveform of a signal, allows measurement of frequency, timing, peak excursion, offset, ... Psophometer
Ideally the measuring device should not affect the circuit parameters i.e., the internal impedance of the ammeter should be zero (no voltage drop over the ammeter) and the internal impedance of the voltmeter should be infinite (no current through the voltmeter). However, in actual case, ammeters have a low but non zero impedance and voltmeters ...
An electrostatic voltmeter uses the attraction force between two charged surfaces to create a deflection of a pointer directly calibrated in volts. Since the attraction force is the same regardless of the polarity of the charged surfaces (as long as the charge is opposite), the electrostatic voltmeter can measure DC voltages of either polarity.
A modern electrometer is a highly sensitive electronic voltmeter whose input impedance is so high that the current flowing into it can be considered, for most practical purposes, to be zero. The actual value of input resistance for modern electronic electrometers is around 10 14 Ω, compared to around 10 10 Ω for nanovoltmeters. [9]
Multimeter, combines the functions of ammeter, voltmeter, and ohmmeter as a minimum. LCR meter, combines the functions of ohmmeter, capacitance meter, and inductance meter. Also called component bridge due to the bridge circuit method of measurement.
They made the volt equal to 10 8 cgs units of voltage, the cgs system at the time being the customary system of units in science. They chose such a ratio because the cgs unit of voltage is inconveniently small and one volt in this definition is approximately the emf of a Daniell cell , the standard source of voltage in the telegraph systems of ...